Na'urar Motion Sensor Module BYC-WB-D1 bisa BISS0001 don Arduino

Na'urar Motion Sensor Module BYC-WB-D1 bisa BISS0001 don Arduino

Bayanin Kayan Aiki

Cikakkun Bayanai na Datasheet

• Tabbatar da ingantaccen wutar samarwa tsakanin 5 V da 12 V.
• Kula da iyakokin wutar lantarki akan fil ɗin fitarwa don hana lalacewa.
• Kiyaye ingantaccen haɗin ƙasa don guje wa ƙararrawar ƙarya.
• Yi amfani da resistor ɗin ja-ƙasa idan ya cancanta don daidaita fil ɗin fitarwa.
• Sake duba haɗin filaye kafin kunna wutar lantarki.

Umarnin Haɗin Waya

Misalan Lamba & Bayani

int count = 0; // kawai ƙidaya daƙiƙa
int buzzer = 11; // fil don haɗawa da ƙararrawa ko relay

void setup() {
  Serial.begin(9600);
  pinMode(buzzer, OUTPUT); // saita fil 11 a matsayin fitarwa
}

void loop() {
  int v = analogRead(A0); // karanta fil ɗin fitarwa na na'urar
  if (v == LOW) {
    digitalWrite(buzzer, LOW); // saita fil ɗin ƙararrawa LOW
    count = 0; 
  } else {
    count++;
    digitalWrite(buzzer, HIGH); // Saita fil ɗin ƙararrawa HIGH
    Serial.print(count);
    Serial.println("-An gano");    
  }
  delay(1000); // jira daƙiƙa 1
}

Zanga-zanga / Abin da za ku Yi Tsammani

Hotuna

Motion sensor module BYC-WB-D1 based on BISS0001 for Arduino

Motion sensor module BYC-WB-D1 based on BISS0001 for Arduino

/*
 * This is code for the module BYC-WB-D1 based on BISS0001 Micro Power motion detection IC
 * Written by Ahmad Shamshiri for RoboJax.com
Date modified: Jun 30, 2018 at 17:45 in Ajax, Ontario, Canada

Watch the video instruction for this code: https://youtu.be/h9JDlQXpi2w
You can get this code from RoboJax.com

Pin connection
VCC to 5V
GND to GND
OUT to pin 11 of Arduino
 */

int count =0;// just counting seconds
int buzzer = 11;// pin to connect to buzzer or relay
void setup() {
  Serial.begin(9600);
  pinMode(buzzer,OUTPUT);// set pin 11 as output

}

void loop() {
  int v = analogRead(A0);// read the output pin of the module
   // HIGH is when motion is detected. 
  if (v == LOW){
    digitalWrite(buzzer,LOW);// set buzzer pin LOW
   count =0; 
  }else{
    count++;
    digitalWrite(buzzer,HIGH);// Set buzzer pin HIGH
    Serial.print(count);
    Serial.println("-Detected");    
  }
 delay(1000);// wait for 1 second
}