/*
 * S01-07 Additional 5V or GND pin.
If your Arduino board voltage is 3.3V, then we will get 3.3V and GND pin

 * Arduino Sketch to give you extra 5V pin from Arduino
  Please watch video instruction here https://youtu.be/pQKrl5Kpi50
 This code is available at http://robojax.com/course1/?vid=lecture07

with over 100 lectures Free On YouTube. Watch it here http://robojax.com/L/?id=338
Get the code for the course: http://robojax.com/L/?id=339 
 * Written by Ahmad Shamshiri for Robojax, robojax.com http://youtube.com/robojaxTV
 * on Jan 01, 2019 at 08:54 in Ajax, Ontario, Canada
 * 
 */
#define VCC2  5 // define pin 5 or any other digital pin here as VCC2
#define GND2  2 // define pin 2 or any other digital pin as Ground 2

void setup() {
    
  pinMode(VCC2,OUTPUT);//define a digital pin as output
  digitalWrite(VCC2, HIGH);// set the above pin as HIGH so it acts as 5V

  pinMode(GND2,OUTPUT);//define a digital pin as output
  digitalWrite(GND2, LOW);// set the above pin as LOW so it acts as Ground  

}

void loop() {
	//Robojax Step By Step Arduino Course http://robojax.com/L/?id=338


}