Robojax Touch Counter V1 (basic counter)

Project Video
Project Details

This Arduino code make simple touch counter. Every time touch module TTP223/TTP223B is touched, the counter number increases and displayed on the serial monitor in Arduino. You can view Serial MOnitor by pressing Ctrl+Shift+M on your PC. There is a reset button which you can reset the counting at any time.

TTP223 or TTP223B module with a single push button is used to make this counter. Any Arduino boards can be used.

Project Code

*
 * This is Arduino Robojax Touch counter using TTP223/TTP223B
 * this program will function as counter. Every time the touch module is touch
 * the counter increments +1 to the counter.
 * We have got a reset button to restart the counting from zero.
 * 
 * Watch video instruction for this video:https://youtu.be/zJ-yd4vYn8s
 * 
 * Written by Ahmad Shamshiri on Saturday 27th of October at 14:40 in Ajax, Ontario, Canada
 * Get this code from Robojax.com
 * 
 * This code is "AS IS" without warranty or liability. Free to be used as long as you keep this note intact.* 
 * This code has been download from Robojax.com
    This program is free software: you can redistribute it and/or modify
    it under the terms of the GNU General Public License as published by
    the Free Software Foundation, either version 3 of the License, or
    (at your option) any later version.

    This program is distributed in the hope that it will be useful,
    but WITHOUT ANY WARRANTY; without even the implied warranty of
    MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
    GNU General Public License for more details.

    You should have received a copy of the GNU General Public License
    along with this program.  If not, see .
 */

const int touchPin = 2;// the input pin where touch sensor is connected
const int resetPin = 12;// the input pin for reset button
const int touchDelay = 10;//millisecond delay between each touch

int count=0;// variable holding the count number

void setup() {
 // Robojax.com Touch counter 20181027
  Serial.begin(9600);// initialize serial monitor with 9600 baud
  Serial.println("Robojax Touch Counter");  
  pinMode(touchPin,INPUT);// define a pin for touch module
  pinMode(resetPin,INPUT_PULLUP);// define a pin for reset button
  // see video ( http://bit.ly/pushbutton-resistor) on using PULLUP

  
  // Robojax.com Touch counter 20181027        
}

void loop() {
  // Robojax.com Touch counter 20181027
  int touchValue = digitalRead(touchPin);// read touchPin and store it in touchValue

  // if touchValue is HIGH
  if(touchValue == HIGH)
  {

    count++;// increment the count

      Serial.print("Touched ");//print the information
      Serial.print(count);//print count
      Serial.println(" times.");        
    delay(touchDelay);// touch delay time
  }

   // if reset switch is pushed
   if(digitalRead(resetPin) == LOW)
   {
    count =0;// reset the counter;
      Serial.println("Counter Resetted.");//print the information
    
   }

  // Robojax.com Touch counter 20181027
}
Required File(s)