Other Arduino Codes and Videos by Robojax

How to use Heltec LoRa CubeCell Development Board HTCC-AB01

Patrons Early Access

How to use Heltec LoRa CubeCell Development Board HTCC-AB01

In this video we learn how to use Heltec CubeCell LoRa Development module. CubeCell is explained, GPIO pins explained, getting driver for Arduino IDE and Reinstalling is shown. Where to purchase it and the documentation is explained. RGB LED control is demonstrated. Each GPIO pin is shown by connecting an LED to them. Two CubeCell is used to send text from one and received by the other. Also using one CubeCell as remote push button Transmitter (TX) and the other CubeCell as as receiver (RX) to turn ON/OFF an LED remotely.

The Board Manager URL https://resource.heltec.cn/download/package_CubeCell_index.json

Chapters of this video Tutorial

• 00:00 Start of presentation
• 01:23 Introduction
• 01:58 Hardware Explained
• 05:45 CubeCell Pins explained
• 10:08 Demonstration: RGB LED control
• 10:57 Demonstration: GPIO pins
• 12:24 Sending data between two CubeCell module
• 18:21 Turning ON/OFF LED using two CubeCell module

JSON

• CubeCell HTCC-AB01 Product Page (Heltec.org)
• CubeCell HTCC-AB01 Quick Start Guide (Documentioan)
• CubeCell HTCC-AB01 Schematic (pdf)
• CubeCell Repository(GitHub)
• ASC6501 MCU PSoc Datasheet (pdf)

If you found this tutorial helpful, please support me so I can continue creating content like this. You can support me on Patreon ( Launched June 14, 2019): http://bit.ly/2ZnITLz

Or support me via PayPal