Arduino code to use NJK-5002C hall sensor

Project Video
Project Details

This is the Arduino code to use NJK-5002C hall sensor to control DC or AC load with and without Arduino

Fig. 1 Wiring of NJK-5002C Hall Proximity Sensor

Fig. 2 wiring diagram of NJK-5002C proximity sensor with 5V Relay module

Project Code

 * This is the Arduino code to use NJK-5002C hall sensor to control  DC or AC load
 * In the video I have explained that this can be used without Arduino and with Arduino 
 * watch video instruction on video :
 * Written by Ahmad Shamshiri for Roboja Video,
 * Date: Nov 10, 2018 on Saturday at 09:34 in Ajax, Ontario, Canada

 * Please keep this note with the code.
 * This code is available on
 * This code is "AS IS" without warranty or liability. Free to be used as long as you keep this note intact.* 
 * This code has been download from
    This program is free software: you can redistribute it and/or modify
    it under the terms of the GNU General Public License as published by
    the Free Software Foundation, either version 3 of the License, or
    (at your option) any later version.

    This program is distributed in the hope that it will be useful,
    but WITHOUT ANY WARRANTY; without even the implied warranty of
    GNU General Public License for more details.

    You should have received a copy of the GNU General Public License
    along with this program.  If not, see .

#define sensorPin  2 // pin 2 
#define relayPin 8 // pin

const int wait = 3000;// after switched ON, wait for this amount of time

void setup() {

  // 20181110 NJK-5002C hall sensor
  pinMode(sensorPin, INPUT_PULLUP);// define pin  as input for sensor
  // watch video explaining the INPUT_PULLUP
  pinMode(relayPin, OUTPUT);// defind pin as output

  Serial.begin(9600);// initialize serial monitor with 9600 baud.

void loop() {
  // 20181110 NJK-5002C hall sensor
  int sensed = digitalRead(sensorPin);// read pin 2 and put the result in the "sensed" variable
  if(sensed == LOW){
    digitalWrite(relayPin, LOW);// if sensed turn relay ON
    delay(wait);// keep the relay ON for the "wait" amount of time
    digitalWrite(relayPin, HIGH);// else turn the relay OFF
 delay(300);// delay for 0.3 seconds
  // 20181110 NJK-5002C hall sensor

If you found this Arduino course helpful, please support me so I can continue creating content like this. support me via PayPal